We just bought a Motorola GM300 on ebay for remote program and control and asked the person to program it he sent me a message he needs to know this info
RX Freq
TX freq
RX SQ type (CSQ DPL TPL) and code
TX Sq Type (CSQ DPL TPL) and code
TX inhibit on busy Y/N
Local/Distant (L/D)
TOT (time)
Handset Y/N
Forced monitor on/off
Accessory connector (Modes => general I/O, phone patch, paging, RPBSO, Radius RICK RX, Radius RICK TX, Community Rmt, Phn Base PA) and then each of these screens have some programmable pins on the accessory connector (there is a table of settings you can do on it)
What should I tell him?
its a UHF radio and has 16 channels and 16 pin connector.
I also bought the premade cable from the radio to the controller from someone else
Thanks in advance for any help
Mitch
N2RGA
GM300 on port 2 of RC-210 Controller
Moderator: Queue Moderator
Re: GM300 on port 2 of RC-210 Controller
Got the info just need to know if its active high or low on pin 8
need to know if the two pins 8 and 12 are "active low" for carrier detect and PL detect.
8 is CSQ Detect
12 is PL/DPL & CSQ Detect
need to know if the two pins 8 and 12 are "active low" for carrier detect and PL detect.
8 is CSQ Detect
12 is PL/DPL & CSQ Detect