MT2000 & QCII
Posted: Tue Dec 30, 2003 5:40 pm
I am trying to program an MT2000 with quick call II. Here are the specifics:
A tone: 672.0
B tone: 294.7
C tone: 1082.0
A-B/A-C decode format.
Here is the problem. The radio works fine when decoding the A-C format, but will not trigger on the A-B format when dispatched by our county comm center. I have used an HT-1250 to transmit the tones, and it works fine with that. I am assuming that the county's tones are a hair off and that is why the radio won't decode the tones.
Is there anything in the RSS that would allow for more a a deviation in decoding the tones, or is it a matter of just playing around with tones and taking them up or done a few tenths of a Hz to try and get it right?
Any help is always appreiciated. Thanks in advance.
A tone: 672.0
B tone: 294.7
C tone: 1082.0
A-B/A-C decode format.
Here is the problem. The radio works fine when decoding the A-C format, but will not trigger on the A-B format when dispatched by our county comm center. I have used an HT-1250 to transmit the tones, and it works fine with that. I am assuming that the county's tones are a hair off and that is why the radio won't decode the tones.
Is there anything in the RSS that would allow for more a a deviation in decoding the tones, or is it a matter of just playing around with tones and taking them up or done a few tenths of a Hz to try and get it right?
Any help is always appreiciated. Thanks in advance.