MC2000 wiring

The General forum is where users can discuss any topic regarding Motorola communications equipment - hardware, software, etc. There are also several focused forums on this board, so please take the time to ensure that your questions doesn't fall into one of those categories before posting here!

Moderator: Queue Moderator

Post Reply
maxjam
Posts: 124
Joined: Fri Sep 07, 2001 4:00 pm

MC2000 wiring

Post by maxjam »

I just picked up a MC2000 deskset. However it didn't come with a manual. Can somebody tell me the connections for 2 wire tone remote? I was hoping it would come
with a standard default channel 1 -16 tones, however it appears only 1 channel is setup. If there is a default config with more then one channel, is there a button-hold-reset
that I could do?

Thanks.
User avatar
wavetar
Administrator
Posts: 7339
Joined: Sun Sep 09, 2001 4:00 pm

Re: MC2000 wiring

Post by wavetar »

Unfortunately, you'll need the programming CPS, part# RVN4178, to make most changes & add more channel capabilities. The programming cable is part# DDN6367.

You'll really need the manual, part# 6880309K85...but you'll probably pay more for that than you did for your used MC2000.

I have the MC2000 'quick connect' set-up guide in pdf format that I can email you which can help you with some things. PM me with your address. It shows the pinouts for the audio port & even the programming/printer cable.
No trees were harmed in the posting of this message...however an extraordinarily large number of electrons were horribly inconvenienced.

Welcome to the /\/\achine.
Post Reply

Return to “General Motorola Solutions & Legacy Radio Discussion”