MV Squelch and NB
Posted: Fri May 10, 2013 6:23 pm
It has been some time since I posted last, but I wanted to share with you guys something I found on my MV pager and wanted to see what thoughts any of you have.
I posted before that my pager would not receive in monitor at all ( Somewhat common problem with the MV ) and it would still go off if a call was received, but the audio was very low. Today I changed the settings from WB to NB and guess what....... The pager starting working again. I changed it back to WB and it went back to being a POS again. I have no clue on why it is doing this, but for now I am going to leave it in NB and see what happens. I will keep you guys updated.
After doing some searching I could still not find a no BS answer for this question...... On the Squelch setting bar ( 1-5 ) what setting is for what ? All I can find is everyone going back and forth on 1 being lose and tight... I do know 3 is default and what would be the best setting for running NB in a area weak signal ?
Thanks for the help
I posted before that my pager would not receive in monitor at all ( Somewhat common problem with the MV ) and it would still go off if a call was received, but the audio was very low. Today I changed the settings from WB to NB and guess what....... The pager starting working again. I changed it back to WB and it went back to being a POS again. I have no clue on why it is doing this, but for now I am going to leave it in NB and see what happens. I will keep you guys updated.
After doing some searching I could still not find a no BS answer for this question...... On the Squelch setting bar ( 1-5 ) what setting is for what ? All I can find is everyone going back and forth on 1 being lose and tight... I do know 3 is default and what would be the best setting for running NB in a area weak signal ?
Thanks for the help