Minitor II Set 8

This forum is focused on discussing Digital and Voice paging equipment, protocol's, infrastructure, and Motorola specific hardware used. Please refrain from discussing different ways to monitor the digital paging systems due to the legalities of such.

Moderator: Queue Moderator

Post Reply
cgroftmc
Posts: 89
Joined: Thu Oct 18, 2001 4:00 pm

Minitor II Set 8

Post by cgroftmc »

I am trying to set up a Minitor II for Set 8 (A-b, C-B) however there is no 3c3 jumper on the board. I am assuming that my board is a different revision than the one on the batlabs site. Any info would be helpful. Thanks!!!

Craig
MOTO_LR
Posts: 101
Joined: Sun Jul 24, 2005 12:46 pm

Re: Minitor II Set 8

Post by MOTO_LR »

Craig,

Jumper 3C3 applied to early Minitor II Decoder Boards, like model NRN5493A.

Your decoder board should be labeled NRN6190A

If so, Jumper Set 8 (option R177) A-B, C-B is as follows:

3C1 OUT
3C2 OUT
3C4 IN
3C5 OUT
3C8 OUT (requires cutting the circuit)
3C9 IN
3C10 IN
3C11 OUT (requires cutting the circuit)

Hope this helps.

Bob, CLARKCOMM
cgroftmc
Posts: 89
Joined: Thu Oct 18, 2001 4:00 pm

Re: Minitor II Set 8

Post by cgroftmc »

Great, thanks!!

Craig
Post Reply

Return to “Motorola Digital and Voice Paging”