Users may not create topics, posts, or private messages containing or relating to the following material (especially pertaining to Motorola copyrighted software, unless you want Motorola to come along and shut this site down):

  • Listing for sale or trade of, or links to sites offering for sale or trade of, or giving away, Radio
    Service Software (RSS) or Customer Programming Software (CPS)
  • Profanity, pornography, defamation, or slanderous remarks directed towards any individual or entity
  • Commercial advertising (except in the Batboard Vendors forum, as approved by the Admin/Mod Staff)
  • Any other items which may be deemed as offensive

If any topics, posts, or private messages containing or relating to the aforementioned material are brought to the attention of the Admin/Mod Staff, they will be deleted.

Additional FAQ items appear here in Forum Rules. Please review them for posting guidelines and further clarification.

M1225 internal speaker pin location

This forum is for discussions regarding all aspects of Motorola radio programming, including hardware, computers, installation and use of RSS/CPS, firmware upgrades, and troubleshooting. There are subforums for discussions of codeplugs, and also for software/firmware release notes and issues.

Moderator: Queue Moderator

p38chief
New User
Posts: 1
Joined: Sun Dec 01, 2019 3:18 pm

M1225 internal speaker pin location

Postby p38chief » Sun Dec 01, 2019 3:55 pm

Hi. I’m new here,, I have a M1225, I’m hooking up an external speaker, and I still want the internal speaker to also work. I know I need a jumper on the plug for the external speaker plug I have. What pins do I jump ? 8/10 or 7/9 ? Thanks.

User avatar
fineshot1
Posts: 1042
Joined: Wed Oct 12, 2005 5:13 am

Re: M1225 internal speaker pin location

Postby fineshot1 » Mon Dec 02, 2019 11:48 am

The accessory connector pins on the rear of this radio are pin 1 and 16.
Don't know if you need to jumper anything but pin 1 = external speaker -
and pin 16 = external speaker +
fineshot1
NJ USA

RFguy
Posts: 1356
Joined: Wed Dec 21, 2005 6:17 am

Re: M1225 internal speaker pin location

Postby RFguy » Mon Dec 02, 2019 12:59 pm

There is no jumper required. The external speaker runs in parallel with the internal speaker. Just hook up the external speaker to pins 1 and 16.

if you want to disconnect the internal speaker, you need to cut jumper JU501 or disconnect the internal speaker at the speaker.

Note: The M1225 only supports an 8 ohm external speaker. Don't use a 4 ohm or 2 ohm speaker.


Return to “Radio Programming”

Who is online

Users browsing this forum: No registered users and 2 guests