Quantar T5365A Receiver Mute

This forum is for discussions regarding all aspects of Motorola radio programming, including hardware, computers, installation and use of RSS/CPS, firmware upgrades, and troubleshooting. There are subforums for discussions of codeplugs, and also for software/firmware release notes and issues.

Moderator: Queue Moderator

Post Reply
EagleTest_Jim
New User
Posts: 8
Joined: Sun May 04, 2014 7:11 pm

Quantar T5365A Receiver Mute

Post by EagleTest_Jim »

I am using this quantar as a base station to talk to a local repeater. The only problem I am having is that the receiver does not mute. I have the quantar set as a base, not a repeater, but the receiver stays on when the PTT is pressed. The mic is a HMN1001B connected into the port on the front panel of the SC. I am using two antennas at the moment. The TX is on the roof and the RX inside the building, it picks up the repeater just fine.

I have studied the RSS book and I can't find the setting that would mute the receiver in TX. I can't find anything in the hardware book that explains how the mute works in this radio. Would appreciate any help on this.

Thanks
Post Reply

Return to “Radio Programming”