XPR8400 Repeater Stuck in Disabled Mode

This forum is for discussions regarding all aspects of Motorola radio programming, including hardware, computers, installation and use of RSS/CPS, firmware upgrades, and troubleshooting. There are subforums for discussions of codeplugs, and also for software/firmware release notes and issues.

Moderator: Queue Moderator

Post Reply
tztop10
Posts: 34
Joined: Mon Sep 29, 2014 2:08 am
What radios do you own?: HT1250 EX600XLS CDM1250 CP200

XPR8400 Repeater Stuck in Disabled Mode

Post by tztop10 »

I programmed it but do not understand why the disabled light keeps blinking...

The blinking Red LED "Disabled" means:
Blinking RED= Repeater in self-test mode.
Top
rwcidade
New User
Posts: 2
Joined: Wed Oct 08, 2008 5:19 am

Re: XPR8400 Repeater Stuck in Disabled Mode

Post by rwcidade »

The problem is in the ethernet card, IC card should be pifado this, it happens followed when there is no protection at ETH network.
Replace C or ethernet card that works normally.
Top
tztop10
Posts: 34
Joined: Mon Sep 29, 2014 2:08 am
What radios do you own?: HT1250 EX600XLS CDM1250 CP200

Re: XPR8400 Repeater Stuck in Disabled Mode

Post by tztop10 »

It's Not using Ethernet at all
Top
Post Reply

Return to “Radio Programming”