Users may not create topics, posts, or private messages containing or relating to the following material (especially pertaining to Motorola copyrighted software, unless you want Motorola to come along and shut this site down):

  • Listing for sale or trade of, or links to sites offering for sale or trade of, or giving away, Radio
    Service Software (RSS) or Customer Programming Software (CPS)
  • Profanity, pornography, defamation, or slanderous remarks directed towards any individual or entity
  • Commercial advertising (except in the Batboard Vendors forum, as approved by the Admin/Mod Staff)
  • Any other items which may be deemed as offensive

If any topics, posts, or private messages containing or relating to the aforementioned material are brought to the attention of the Admin/Mod Staff, they will be deleted.

Additional FAQ items appear here in Forum Rules. Please review them for posting guidelines and further clarification.

XTL2500 question on TX PL encode programming

This forum is for discussions regarding all aspects of Motorola radio programming, including hardware, computers, installation and use of RSS/CPS, firmware upgrades, and troubleshooting. There are subforums for discussions of codeplugs, and also for software/firmware release notes and issues.

Moderator: Queue Moderator

Jim202
Posts: 3567
Joined: Sun Sep 09, 2001 4:00 pm

XTL2500 question on TX PL encode programming

Postby Jim202 » Thu Feb 01, 2007 6:15 am

I have found that if the XTL2500 receiver is programmed for
carrier squelch on a channel, you can't set the TX to do PL
encode. The area is shaded out and won't allow it to be set.

If you set the RX channel to be PL decode, then you can
set the TX for PL encode just fine.

I don't remember this being an issue with the older version
of the RSS. I am using the Astro 25 CPS version R09.00.00.

Has anyone any idea how to get around this problem? Or
is this another Motorola screw job and they didn't think it
would ever need to be programmed this way.

Jim

RocketNJ
Posts: 584
Joined: Sat Oct 13, 2001 4:00 pm

Postby RocketNJ » Thu Feb 01, 2007 7:45 am

Just checked a codeplug here with CPS version 9. Cannot repro your problem.

Check the personality you are using with the zone/channel entry. Make sure it is set for analog tx.

User avatar
GEMOTO
Posts: 415
Joined: Fri Jan 09, 2004 6:15 pm

Postby GEMOTO » Thu Feb 01, 2007 9:06 am

I tried it with one here and could not duplicate it. I am having another issue with one of these radios regarding PL decode after quick sucessive transmissions. When I get time later today I'll upload a document I wrote describing it. It probably not relavant but its good information to have anyway.

User avatar
wavetar
Administrator
Posts: 7337
Joined: Sun Sep 09, 2001 4:00 pm

Postby wavetar » Thu Feb 01, 2007 10:52 am

Send me your codeplug, for kicks & giggles. I haven't worked with any XTL2500 units yet (lots of 1500 & 5000's), so wouldn't mind playing with a codeplug.

mailto:wavetar@eastlink.ca

Todd
No trees were harmed in the posting of this message...however an extraordinarily large number of electrons were horribly inconvenienced.

Welcome to the /\/\achine.


Return to “Radio Programming”

Who is online

Users browsing this forum: No registered users and 1 guest