Page 1 of 1

MTR3000 On 900MHZ ham band-Need Help?

Posted: Mon Oct 08, 2018 10:38 am
by rfimage
I have a Motorola MTR3000 I have acquired-It is a MTR2000 Converted to a MTR3000-I have Used HDX Hex Edit and it works on hex Convert-As soon as I try and load Converted Code plug the repeater rejects and says hardware does not support the freq range and will not let me program?
I have converted XPR8380 and XPR6580 to Ham freq 900 MHZ with no problem. I can not get this MTR3000 to go to ham freq?, Do I need special software? My freqs are 927.9125TX/902.9125RX. Thanks for all the help with my project here in Las Vegas, NV

Re: MTR3000 On 900MHZ ham band-Need Help?

Posted: Tue Jul 30, 2019 4:44 pm
by sglass
Did you have any luck with this?

Re: MTR3000 On 900MHZ ham band-Need Help?

Posted: Sat Mar 18, 2023 7:55 pm
by BigJoeW
I know I’m a little late to the thread- but also seeking a solution here as well. Following at the least!

Re: MTR3000 On 900MHZ ham band-Need Help?

Posted: Mon Mar 20, 2023 9:22 am
by sglass
nope, :o don't work

Re: MTR3000 On 900MHZ ham band-Need Help?

Posted: Wed Mar 29, 2023 2:32 am
by VE3TUH
Just curious, do both rx and tx error when trying out of band? I know the mtr2000 uses a resistor array in the pa to determine band, it may be the same with the 3000.

Re: MTR3000 On 900MHZ ham band-Need Help?

Posted: Wed Mar 29, 2023 6:17 pm
by sglass
You can't write the freqs to the radio. It bounces. No one I know has gotten this to work.