xpr-4550 remote mount invalid front accessory error

Moderator: Queue Moderator

Post Reply
miken8eqd
Posts: 18
Joined: Thu Dec 28, 2006 9:00 pm

xpr-4550 remote mount invalid front accessory error

Post by miken8eqd »

Hello,
I have a uhf xpr-4550 with remote control head.

All I did was move the radio from one vehicle to another.

When it Powers up, the radio beeps and displays "Invalid front accessory" and I get no tx analog/digital.

I unplugged the microphone from the control head and powered the radio up and no error

I plugged in the programming cable into the microphone Jack and the radio recognized the cable. Tryed to read the radio and get a error.

So I unplugged the cable, plugged in the microphone at the RF deck and radio works fine. Same with the programming cable and the software read the codeplug
I checked the pins and they seem to be ok.

Where do I look?

Tnx
Mike
Jim202
Posts: 3609
Joined: Sun Sep 09, 2001 4:00 pm

Re: xpr-4550 remote mount invalid front accessory error

Post by Jim202 »

With the programming cable connected to the radio and computer, try turning off the radio and then back on. I have seen a connection problem show up now and then and the power cycle of the radio generally gets the computer to talk to the radio.

Jim
miken8eqd
Posts: 18
Joined: Thu Dec 28, 2006 9:00 pm

Re: xpr-4550 remote mount invalid front accessory error

Post by miken8eqd »

Jim,
I tried turning the power off, then on.. I tried unplugging power too. It might be a bad pin or a princess pushed back in the body of the connector.
Post Reply

Return to “MotoTRBO Portables and Mobiles (4xxx/6xxx) 1.0 Series Subscribers”