Group Call receive tone
Moderator: Queue Moderator
- marcosorourke
- Posts: 75
- Joined: Thu Nov 13, 2008 7:07 pm
- What radios do you own?: XPR7550
Group Call receive tone
When you make an All Call or a Private Call on the TRBOs the receiving units have an alert tone before the audio comes through. When you make a group call there is no tone, just audio coming out of the speaker. Is there a way in the CPS to enable this tone?
Re: Group Call receive tone
The only tone available on a group call is the channel free indication tone which is in the general settings tab under tones.
When checked it gives you the same tone at the end of a received transmission as when you are in a private call.
When checked it gives you the same tone at the end of a received transmission as when you are in a private call.
- marcosorourke
- Posts: 75
- Joined: Thu Nov 13, 2008 7:07 pm
- What radios do you own?: XPR7550
Re: Group Call receive tone
Blast... That's too bad. Ok, thank you for your help!
-
- Posts: 151
- Joined: Mon Apr 14, 2003 5:09 pm
Re: Group Call receive tone
They actually do have Group Call receive tones that beep prior to transmission. Right in the CPS.
Suddenly You Were Gone
- marcosorourke
- Posts: 75
- Joined: Thu Nov 13, 2008 7:07 pm
- What radios do you own?: XPR7550
Re: Group Call receive tone
I'm looking in the CPS and not seeing it. Where would I find that?
-
- Posts: 151
- Joined: Mon Apr 14, 2003 5:09 pm
Re: Group Call receive tone
Contacts->Digital->Call
right under where you put the call ID there is a check box...if you have NOT updated the Firmware and CPS you will NOT see this option.
right under where you put the call ID there is a check box...if you have NOT updated the Firmware and CPS you will NOT see this option.
Suddenly You Were Gone