Page 1 of 1

Tool to Calculate WACN & System ID or Call Sign

Posted: Sat Aug 17, 2013 9:34 am
by rsantina
I found a great tool to calculate WACN and System ID based on Call Signs.
I had found Eric's tool but it only went one way - WACN and System to Call.
I was looking for a simple way to put in a Call and generate the WACN and System; the spec is a bit confusing to say the least...
I finally found a single tool that converts to and from and includes a tool for SNE based setup too. It is on the right side of this page marked "P25 Calculator".
http://www.cisco.com/go/ipics
A Project 25 tool from, of all places, Cisco.

Re: Tool to Calculate WACN & System ID or Call Sign

Posted: Sat Aug 17, 2013 1:03 pm
by Bigfella237
Doesn't work for me? I get this error:

"Invalid characters found in WACN ID. Only the digits 0-9 are allowed."

Andrew

Re: Tool to Calculate WACN & System ID or Call Sign

Posted: Sat Aug 17, 2013 5:52 pm
by MTS2000des
same here, and all the known callsigns I put in, spit out a completely different SYS ID and WACN