XTL5000 High Power O3 Control Head

[jts203]

Does anyone know if you can configure a high power XTL5000 for the O3 handheld control mic/head. The reason I ask is because I notice the radio I have does not have the rear accessory connector on the radio as does the low poer unit and don't know how the speaker/ignition sense would hook up. Radio is currently configured remote with an O5 head.

Thank you

[akardam]

http://batboard.batlabs.com/viewtopic.php?t=74275

[jts203]

I'm also looking for a little info on the XTL5000 high power remote 25 pin accessory connector pinout. I have it listed below, but I'm not sure which pin would be for ignition sense.

1 AUX PTT
2 DCE_TXD
3 DCE_RXD
4 DCE_CTS
5 BUS+
6 RX FILT AUDIO
7 AUX_RX
8 AUX_TX
9 RX FILT AUDIO
10 ANA_GND
11 MIC_LO
12 MIC_HI
13 EMERGENCY
14 BUS-
15 MONITOR
16 CHAN ACT
17 DCE_RTS
18 DIG_GND
19 RESET
20 A+
21 BUS_SHIELD
22 SWB+
23 BUSY
24 SPKR-
25 SPKR+

[jmr061]

Not sure where you got your pinout listing from. Here is the correct one from the O3 service manual:

J600
Table 3-14 - J600 pin output
PIN PIN NAME
J600-1 AUX_PTT
J600-2 RS232_RX= UARTA_TX= DCE_TX
J600-3 RS232_TX= UARTA_RX= DCE_RX
J600-4 RS232_RTS= UARTA_RTS= DCE_CTS
J600-5 BUS(+) (SB9600)
J600-6 RX_AUDIO
J600-7 AUX_RX
J600-8 AUX_TX
J600-9 RX_AUDIO
J600-10 GND
J600-11 GND
J600-12 DAC_OUT
J600-13 EMERGENCY
J600-14 BUS(-) (SB9600)
J600-15 VIP_OUT_1
J600-16 IGN
J600-17 RS232_CTS=UARTA_CTS=DCE_RTS
J600-18 GND (legacy)
J600-19 RESET (SB9600)
J600-20 A+
J600-21 GND (SHIELD)
J600-22 SW_B+
J600-23 BUSY (SB9600)
J600-24 SPEAKER(-)
J600-25 SPEAKER(+)

[ka8ypy]

So to make my own cable for the DB25, I need pins 16 (IGN), 24(SPKR-), 25(SPKR+).

Do I need to do anything with pin 13(EMERG)? I.E. do I need to ground it as on the 26 pin accessory connector for a dash mount?

Thanks,

DB

PS - Sorry to be a Post Lazarus

[jmr061]

Ign and Speaker outputs are all I ever used. Should be good to go.

Jason

[ka8ypy]

Ign and Speaker outputs are all I ever used. Should be good to go.

Jason

Thanks Jason.

Dan