Cable type T. T. F. 71-254 0310
Moderator: Queue Moderator
Cable type T. T. F. 71-254 0310
I have a jumper cable in an equipment rack with those markings that has been pinched and severed, needing to be replaced. Anyone happen to know the specs on the cable?
Re: Cable type T. T. F. 71-254 0310
Pictures and/or relevant info on the application would be quite helpful.
Re: Cable type T. T. F. 71-254 0310
Cameras not allowed on site. It is a jumper from a receive multi-coupler to an alarm data receiver. The cable fits in a ug-176 adapter not a ug-175(had them handy for comparison). It is a black rubber jacket, bare copper braid, foamed inner, very fine single strand copper center, BNC connectors on both ends. No one is sure if it is an original cable or a replacement cobbled together by a past technician. I have an LMR240 jumper in place now but it "doesn't look the same".
Re: Cable type T. T. F. 71-254 0310
And the answer is 93 ohm.
Found the card for the tech that used to service the system. He said it was a cable he had on his truck left over from a computer networking project that was the right length so he didn't have to take time to make a replacement at O-dark-thirty and forgot to go back and change at the next scheduled service.
The LMR-240 is staying put.
Found the card for the tech that used to service the system. He said it was a cable he had on his truck left over from a computer networking project that was the right length so he didn't have to take time to make a replacement at O-dark-thirty and forgot to go back and change at the next scheduled service.
The LMR-240 is staying put.