Batboard

Alright folks, here comes the "tough" question...

I just recently got a Centracom Gold setup and want to interface my XPR8400 to the punch block. Has anyone done this? If so, can you share the ease of it, wiring diagrams and such? I have the CEB and CIE manuals that came with the setup, but nothing else. I will have to run about 10 feet of cable between where the XPR sits and where the Centracom sits.

Regards,

-Frank C.

Is the XPR8400 running in analog or digital mode?

RFguy wrote:Is the XPR8400 running in analog or digital mode?

It is in Mixed mode.

Regards,

-Frank C.

fchrist16 wrote: It is in Mixed mode.

Regards,

-Frank C.

I won't work in digital, just analog. When you key up from the rear accessory there is no way to specify a time slot or talk group ID. I had this issue interfacing an 8400 with a controller for an amateur repeater in mixed mode.

That's fine, the hookup I'm planning was for the analog side of the repeater anyway...

Regards,

-Frank C.

XPR-8400 Pinout

Pin 21 - COR - Program for COR/PL/ TG Detect
Pin 17 - PTT - Program for PTT
Pin 14 - RX Audio
pin 12 - Audio GND
Pin 11 - TX audio

Afternoon Frank,

Check this device out from Bridgecom

https://www.bridgecomsystems.com/collec ... ducts/mv-1

May be the thing if you want to have digtial to the console

Not sure on the analog should you tell the repeater IPLC is on

CoM