Page 1 of 1

XTL5000 Dash W7 to Remote O5

Posted: Mon May 15, 2017 12:23 pm
by Dystroxic
Hi everyone,

I know that this or similar questions have been asked a lot around here, and I have already read through as many as I could find. However, it looks like specifics for part numbers and instructions vary depending on radio year/model and the general mood of whoever assigns part numbers at Motorola. So, I was hoping I could run this by some of the experts here to see if I'm on the right track.

I have an XTL5000 mid-power radio with a W7 dash mount control head. XTL5000 specs:

XTL5000 model number: M20URS9PW1AN
Firmware: R17.01.01
DSP: R17.01.00
Tuning: R01.08.00
PSDT: R04.00.00

I'm looking to upgrade this to an O5 remote mount control head. The CPS allowed me to change the control head in the software, so the firmware should be compativle. I already have an O5 + CHIB, specs:

O5 model number: HLN1467H
CHIB model number: HLN1468B

So now I need a TIB, Flex cable (transceiver -> TIB), remote mount cable, and power/speaker cable. I think that these part numbers would be:

TIB: PMUN1036 (or 'A' or 'D' versions, not sure of the difference?)
Flex: HKN6190 (or 'C' version, not sure of the difference?)
Remote cable: HKN6170 (again, maybe a version with a letter on the end?)
Power cable: HKN6188

Is this a valid set-up, and will this upgrade work? Thanks for reading!

Re: XTL5000 Dash W7 to Remote O5

Posted: Mon May 15, 2017 2:01 pm
by spectragod
Pm sent,
I have all those parts.