Users may not create topics, posts, or private messages containing or relating to the following material (especially pertaining to Motorola copyrighted software, unless you want Motorola to come along and shut this site down):

  • Listing for sale or trade of, or links to sites offering for sale or trade of, or giving away, Radio
    Service Software (RSS) or Customer Programming Software (CPS)
  • Profanity, pornography, defamation, or slanderous remarks directed towards any individual or entity
  • Commercial advertising (except in the Batboard Vendors forum, as approved by the Admin/Mod Staff)
  • Any other items which may be deemed as offensive

If any topics, posts, or private messages containing or relating to the aforementioned material are brought to the attention of the Admin/Mod Staff, they will be deleted.

Additional FAQ items appear here in Forum Rules. Please review them for posting guidelines and further clarification.

XTS2500 Transmitting After Being Turned Off?

Moderator: Queue Moderator

dlnorth
New User
Posts: 1
Joined: Sun Aug 19, 2018 10:33 am

XTS2500 Transmitting After Being Turned Off?

Postby dlnorth » Sun Aug 19, 2018 11:01 am

I'm trying to figure out how a radio could continue transmitting after the power has been shut off. I was using a lapel mic on my XTS 2500 and after the initial mic key up, the radio continued to transmit, even though I had released the PTT on the mic. When I was advised that my mic was stuck open, I pressed it again a couple of times, hoping to get it to release. When that did not work, I turned off the power, however the radio continued to transmit. The volume switch was in the off position and there were no lights or display visible on the radio. The radio appeared to be off. This continued for about a minute and did not stop until I pulled the battery.

I did not hit the emergency button and there was no indication on my side or the dispatcher's that I did.

Not sure if it matters, but this was on a P25 trunked system.

I am reluctant to use the radio again until I can be sure this will not happen again. I can certainly understand a mic getting stuck, but I've never heard of a radio continuing to transmit after the power has been turned off, unless the emergency button has been pressed, which did not happen in this case. The radio will be going to the shop tomorrow to be checked out, but I'm curious to know if anyone has seen this before or know what could cause this to happen.

ScannerDan
Posts: 409
Joined: Sun Sep 09, 2001 4:00 pm

Re: XTS2500 Transmitting After Being Turned Off?

Postby ScannerDan » Tue Aug 21, 2018 11:09 am

Sounds like an issue with the lapel mic. Did you by chance remove it to see if the problem goes away?
***********************************

I hate arguing with stupid people. They just bring you down to their level and beat you with experience.

RFguy
Posts: 1325
Joined: Wed Dec 21, 2005 6:17 am

Re: XTS2500 Transmitting After Being Turned Off?

Postby RFguy » Tue Aug 21, 2018 12:33 pm

Do a quick test. Transmit on the speaker mic, while holding the PTT button down, turn the radio off. I suspect the radio may not power down until you release the PTT button.

This may help prove it's a bad mic.

Karl NVW
Posts: 89
Joined: Wed Sep 03, 2003 7:13 am

Re: XTS2500 Transmitting After Being Turned Off?

Postby Karl NVW » Sun Aug 26, 2018 1:27 pm

It is possible if the P25 system owner uses positive subscriber access ("whitelist") to detect intruders and then latches them into "Radio Monitor" mode to obtain voiceprint recordings. Another posibility is if the radios are programmed to auto-key after the emergency button is tripped.
Karl - WA8NVW AFA5VB
SHARES + NCS


Return to “ASTRO25 Series (XTS/XTL 1500/2500/5000) Subscribers”

Who is online

Users browsing this forum: No registered users and 30 guests