APX Programming questions

Covering the following Subscriber devices: APX1000/1500, APX3000, APX4000/4500, APX6000, APX6000XE, APX6500, APX7000, APX7000XE, APX7000L, APX7500, and APX8000.

Moderator: Queue Moderator

Post Reply
fyrenut
New User
Posts: 2
Joined: Fri May 26, 2017 6:59 am
What radios do you own?: APX 1000, 4000, 6000, 7000, 8

APX Programming questions

Post by fyrenut »

Good morning,
A few questions if someone has the answer to.
#1 Where can you turn off the backlight on the APX 6000 screen? I know you can set it to to full brightness and lower using the Light/Flip but can it be shut off completely?
#2 is there a chart somewhere that explains all of the choices on buttons? Ie MS0, MPL, Rab 1, etc

Thanks for all of your help!

Jeff
Jeff
User avatar
techtonics
Posts: 83
Joined: Wed Jun 27, 2007 4:47 am

Re: APX Programming questions

Post by techtonics »

To turn off the backlight completely you have to go into:
Radio Ergonomics configurations
Radio Profiles
Default Profile (or whichever you are using)
Un-check Permanent Front Display Backlight

As far as the menu options if you look at the help file for that section it tells you what each means.

But specifically:
MS0 is MS0-MS12 is like quick access buttons for accessing different channels. Like presets on a am/fm car radio
MPL is Mutiple PL for selecting different PL settings on a conv freq.
Rab Repeater access button (preset for sending access codes)
n1gtl
Posts: 113
Joined: Tue Mar 25, 2008 12:43 pm
What radios do you own?: XPR5550, XPR7550e

Re: APX Programming questions

Post by n1gtl »

techtonics wrote:MS0 is MS0-MS12 is like quick access buttons for accessing different channels. Like presets on a am/fm car radio
Thanks for this info but I have a follow up question on this function. In MotoTRBO this is like the OT-1 thru OT-4 button options.
I looked in the help file and it explains WHAT the buttons do but it does not explain WHERE you set the zone/channel you want to access. Where is that?

Thanks,

Jim
John
Posts: 386
Joined: Sun Sep 09, 2001 4:00 pm

Re: APX Programming questions

Post by John »

You set MS0-MS12 like you set presets on an AM/FM radio as a user setting. It is done by going to the channel you want to use as the preset and then pushing and holding the button programmed as MS0 thru MS12 and holding it until it beeps. Then that button is now set that when you push it momentarily it will go to that channel. It is not set in the CPS other than to assign the MS function to the button.
n1gtl
Posts: 113
Joined: Tue Mar 25, 2008 12:43 pm
What radios do you own?: XPR5550, XPR7550e

Re: APX Programming questions

Post by n1gtl »

Thank You!!!
Post Reply

Return to “APX Series Subscribers”