Mobile RF Amplifier Building Project

Moderator: Queue Moderator

Forum rules
Share your enhancements here! What is not permitted is the discussion regarding adding features (aka flash options) which you can still purchase from Motorola for current subscriber products including discussion regarding Depot on current products.
Post Reply
User avatar
fineshot1
Posts: 1097
Joined: Wed Oct 12, 2005 5:13 am

Mobile RF Amplifier Building Project

Post by fineshot1 »

If you have any Motorola MTVA (NTN1322B) = Non band specific Controller Units(No RFPA)
and you have nothing to use it for the heat sink makes for a nice mobile rf pa or even a
small repeater (with lots of wind via a fan) rf pa project. You must take it apart and remove
the controller board but leave the motorola power connector in place. There is a small hole
for the RF Input input connector that was never installed and a rubber plug for another hole that
never had anything populated in its place. I have not tried it but realized this after pulling one
apart. The one i have is partly corroded so i felt i would see if there was anything that it could be
used for.
fineshot1
NJ USA
Post Reply

Return to “Experimental - Mods, and how to do things a little out of the box”