MC2100 aka MCS2000 mobile set
Posted: Thu Oct 05, 2017 4:57 am
Goodmorning !
Looking for an answer to a question on a problem with my Motorola MC2100 (MCS2000 lookalike) I saw your forum ! The problem I have here is that when I put on voltage on the 12 V backside-connector the set immedatley powers up, so when mounted in the car and going to "ignition" the MC2100 goes on the same time.
Is there a solution to solve that, that it stays off ? Had a look at the acc connector, there is a pin called Ignition, what is the function of it ?
Cannot find anything about in on the Internet, or was looking at the wrong place, hi.
Have several MC2100 VHF / UHF, from former Firebrigade and MOD, and like to make it function normally.
Or do I have to put a switch in between the powercord ? Programming isn't the problem, I have sw and hw.
Tnx in advance,
73, de Jan PE1PMO, Netherlands. (also PE1PMO@VERON.NL)
Looking for an answer to a question on a problem with my Motorola MC2100 (MCS2000 lookalike) I saw your forum ! The problem I have here is that when I put on voltage on the 12 V backside-connector the set immedatley powers up, so when mounted in the car and going to "ignition" the MC2100 goes on the same time.
Is there a solution to solve that, that it stays off ? Had a look at the acc connector, there is a pin called Ignition, what is the function of it ?
Cannot find anything about in on the Internet, or was looking at the wrong place, hi.
Have several MC2100 VHF / UHF, from former Firebrigade and MOD, and like to make it function normally.
Or do I have to put a switch in between the powercord ? Programming isn't the problem, I have sw and hw.
Tnx in advance,
73, de Jan PE1PMO, Netherlands. (also PE1PMO@VERON.NL)