HT800 (MT1000) Paperweight?

[T789]

Hi have just been programming one of my HT800's EU version of the MT1000, during programming of radio there was a power cut, Re-booted PC and tried to read radio but RSS now displaying "Radio data invalid - Error 1", have I just got myself a heavy duty paperweight in the shape of a HT800?
Thanks
Paul W

[nvradtec]

if you have a saved codeplug for the radio, send it to the radio without reading it first in most cases it should fix the problem

[kc2dla]

The batlabs site also has some suggestions on correcting a codeplug error.

FYI "Error 1" corresponds to "No Response from the Radio" in Mt1000 RSS R03.01.02.

[Susan157]

We Have Been Able To Clone To A
Bad Radio A Number Of TImes.

It Has Worked For Us In The Past.

[10-95]

I have cleared an HT800 with a corrupted codeplug using the method described for the Genesis series radios in the model specific page, give it a shot.

Frank

[T789]

Thanks for the replys folks have tried the methods on batlabs as described to no avail, has anyone got a codeplug they could possibly email me radio is an 8 channel VHF 157-174MHz MDH43SNU958OAN
thanks
Paul W

[email protected]

[10-95]

You should be able to create a new codeplug for it in the RSS. I'm not sure which version you are using but the one I use will let me create a new codeplug.

Frank

[Monty]

HI:

If you have tried all the proceedures mentioned above,
and have found it not to work, email me direct and perhaps
I can can give you a few tips to restrore the radios " Primary "
code Plug.

[email protected]

Manytimes, the use of a Un-satisfactory program platform
can be the problem, and unless you correct that first, no
proceedure will work.

Monty

[Andreas]

Get HT800 Lab to fix the problem,if the other methodes don´t work.
You can create a default codeplug with it and program the radio.If your channel switch will do more than 8 positions,you can convert your radio into a 16 channel model.

Andreas