XTS3000 Programming Question

This forum is dedicated to discussions pertaining specifically to the Motorola ASTRO line of radios (those that use VSELP/IMBE/AMBE), including using digital modulation, digital programming, FlashPort upgrades, etc. If you have general questions please use the General or Programming forums.

Moderator: Queue Moderator

Post Reply
User avatar
jayres
Posts: 124
Joined: Wed Nov 07, 2001 4:00 pm

XTS3000 Programming Question

Post by jayres »

Ok, here is a question...


Upon power up and self test, my XTS3000 shows a battery level indicator and a signal strength indicator. However, they are not displayed after self test.


I have looked around in the RSS (9.05) and cant find anywhere to enable these.


Is this a lost cause, or am I just blind, or what?


Thanks in advance! :D

Jon
Top
User avatar
wavetar
Administrator
Posts: 7341
Joined: Sun Sep 09, 2001 4:00 pm

Post by wavetar »

The 'battery level indicator' merely blinks when the battery is low, otherwise it does nothing. The RSSI only works with 9600bps firmware & flashcode, apparently.

Todd
No trees were harmed in the posting of this message...however an extraordinarily large number of electrons were horribly inconvenienced.

Welcome to the /\/\achine.
Top
Post Reply

Return to “Legacy Batboard Motorola ASTRO (VSELP/IMBE/AMBE) Equipment Forum”