Users may not create topics, posts, or private messages containing or relating to the following material (especially pertaining to Motorola copyrighted software, unless you want Motorola to come along and shut this site down):
If any topics, posts, or private messages containing or relating to the aforementioned material are brought to the attention of the Admin/Mod Staff, they will be deleted.
Additional FAQ items appear here in Forum Rules. Please review them for posting guidelines and further clarification.
- Listing for sale or trade of, or links to sites offering for sale or trade of, or giving away, Radio
Service Software (RSS) or Customer Programming Software (CPS) - Profanity, pornography, defamation, or slanderous remarks directed towards any individual or entity
- Commercial advertising (except in the Batboard Vendors forum, as approved by the Admin/Mod Staff)
- Any other items which may be deemed as offensive
If any topics, posts, or private messages containing or relating to the aforementioned material are brought to the attention of the Admin/Mod Staff, they will be deleted.
Additional FAQ items appear here in Forum Rules. Please review them for posting guidelines and further clarification.
Off Topic: HELP with EVX534
Moderator: Queue Moderator
Off Topic: HELP with EVX534
Hello all. I'm very new to DMR and vertex programming so forgive me please. I recently purchased 3 evx534s in uhf 403-470 for a steal. All three were brand new in the box with factory codeplugs. I programmed my friends ham repeater into channel 1 and the same analog frequency into channel 2. The analog channel works fine but the DMR channel will only give me about half a mile from the machine before it stops receiving. I can see activity on the channel by the flashing green LED and signal meter shows 2 bars but it just won't unmute. I have also noticed that unless I am very close to the repeater I cannot transmit as well. I get an error message on the display. I've tested this side by side with an xpr7550 which comes in clear and transmits without an issue. All 3 evx 534s act the same which leads me to believe that it's something I'm doing. Firmware was updated to the latest, programming done with CE-151 software and aftermarket cable. Thank you all in advance for your help!
Return to “General Motorola Solutions & Legacy Radio Discussion”
Who is online
Users browsing this forum: No registered users and 0 guests