Hi Motogurus,
Does anyone know if there is a way to store the boot screen configuration in the Motorola R2670?
I recently had to repair the switchmode power supply and replace the memory backup battery in my unit.
After a self cal, the unit works fine, but now when I power up and the unit goes into Monitor mode, on the last used frequency,
the Display section reverts to Modulation scope instead of spec analyser (as was the case before).
Is there a way to set the default boot display to Spec analyser?
I note that memory locations 33 to 44 are labelled 'Factory Default'. Is one of these a boot config??
Thanks guys
Motorola R2670 boot screen
Moderator: Queue Moderator
-
- New User
- Posts: 11
- Joined: Wed Dec 21, 2011 12:34 pm
-
- New User
- Posts: 11
- Joined: Wed Dec 21, 2011 12:34 pm
Re: Motorola R2670 boot screen
Disregard....
Found it in the SPF (Special Functions Menu) menu, under System Functions & then 'Save State'.
Found it in the SPF (Special Functions Menu) menu, under System Functions & then 'Save State'.