MT1000
Moderator: Queue Moderator
- kf4sqb
- Posts: 1491
- Joined: Mon May 19, 2003 9:11 pm
- What radios do you own?: I can't enter that much....
Charlie, I don't quite understand your question. The MT1000 uses the same RIB to PC cable as every other radio. The cable between the RIB and the PC is always the same, no matter what radio. Did you maybe mean the RIB to Radio cable?
kf4sqb "at" wetsnet "dot" com
Look for the new "Jedi" series portables!
Bat-Phone= BAT-CAVE (2283)
-.- .. ....- -.-. -.-- . .. ... -- -.-- -... .-. --- - .... . .-. .-.-.-
Look for the new "Jedi" series portables!
Bat-Phone= BAT-CAVE (2283)
-.- .. ....- -.-. -.-- . .. ... -- -.-- -... .-. --- - .... . .-. .-.-.-
Here is the information
you need.
Also, for the person who needed the MT1000 / HT600 Cable, here
is a alternate link for you !
http://www2.4dcomm.com/metrotech/ht600.jpg
Be advised, the Plate that holds the pins, DOES NOT have
the holes Pre-drilled, and does require 2 Drill sizes if you wish
to have the pins fit tight. What I do is drill a smaller size first,
then use the Body Size drill about 90% of the way. What that
does is when you push the Pin in place, the later part of the
Base with the smaller hole size will help hold the pin in place.
Monty
you need.
Also, for the person who needed the MT1000 / HT600 Cable, here
is a alternate link for you !
http://www2.4dcomm.com/metrotech/ht600.jpg
Be advised, the Plate that holds the pins, DOES NOT have
the holes Pre-drilled, and does require 2 Drill sizes if you wish
to have the pins fit tight. What I do is drill a smaller size first,
then use the Body Size drill about 90% of the way. What that
does is when you push the Pin in place, the later part of the
Base with the smaller hole size will help hold the pin in place.
Monty
Need help on a Program Cable or (/\/\) Rib Box ?
Contact me anytime/All availible / Free Support Info !
mail to: MSisco9939@aol.com
PLease avoid PM's whenever possible. Box gets too full.
Contact me anytime/All availible / Free Support Info !
mail to: MSisco9939@aol.com
PLease avoid PM's whenever possible. Box gets too full.