Batboard

Posted: **Tue Dec 13, 2011 7:03 pm**

Hello all

I had problems sometime ago with the oven light going out after a few minutes and haven't used it for about 3 months. I pluged into the AC and immediately blew the fuse.

Any ideas ???????

thanks
steve w

Posted: **Mon Dec 19, 2011 12:49 pm**

Your primary suspects are the Input module (that you plug your line cord into) or the primary transformer.

Posted: **Sat Mar 03, 2012 7:09 am**

Having the same problem with a R2001C. I can unplug the primary transformer from the power supply board and no longer blows fuse. I do not have a service manual for this unit.

Any suggestions?

Thanks,
Jeremy, KI4CCZ

Posted: **Sat Mar 03, 2012 8:27 am**

I've only seen this once (& I doubt if this is your problem) but disconnect the fan on the back. Also check the xfmr in the LVPS.

Batboard

Blowing 1.5 Amp fuse R2001A Monitor

Blowing 1.5 Amp fuse R2001A Monitor

Re: Blowing 1.5 Amp fuse R2001A Monitor

Re: Blowing 1.5 Amp fuse R2001A Monitor

Re: Blowing 1.5 Amp fuse R2001A Monitor