Batboard

Ok....Who can tell me how to program this thing? I'm going to use it with two maxtracs.

Thanks,
Jay

The i20R has it's own RSS version for programming, which allows you to set repeater direction, hang time, PL regeneration and all sorts of other options. You can use the same programming cable set up as the Maxtrac (RIB & cable to the mic port).
The RSS I found to be a little tempermental; it's the only piece of RSS I've tried that I've had to use MoSlo to get it to work on my laptop.

The ir20 RSS, if you can call it that, should be run with DOS 6.xx and NOT in or with WIN 9x or even Win 9x's version of DOS. BE SAFE!
Some real fast, greater than P166 computers MAY have problems with this "RSS".

Does anybody know what the latest software is available for programming the i20r repeater panel.

it has its own version of rss, i sold one to an old customer for telephone interconnect selctive ringing when in remote places using mdc1200. PM me for some help. Ill do what I can.
Steve

Does any one have the pinout for the i20r cable to attach to a motorola gr1225?

Thank you

It uses the same cabling that a RICK would use.

Thank you for your responce. It uses a Y cable (2 16 pins go into the I20R then obviously 1 goes to the GR1225. The model for the cable is HKN9234. Does anyone know how to make this cable? The list price for it is $73.00 and I am not rich.

Thank you,

If you look on eBay you'll see people selling cables there for about $30 plus shipping for a pair of cables.

And since we are on the subject. anyone have a manual for one of these. I used to have one, but lost it... and I could use another one.