MCS2000 800 mhz programming
Posted: Thu Jul 19, 2012 5:14 am
I have an MCS2000 800 mhz radio that when I use the latest CPS to program the radio I get a runtime termination. I can read the codeplug ok and I don't see anything that would be programmed wrong. When I go to save the codeplug I get the following message and the program terminates. Same also when I try to upload to the radio.
'This program has requested the runtime to terminate it in an unusual way. Contact application support team ~'
I have an MCS2000 900mhz radio and I have no problem programming it or saving the codeplug. I have the Motorola RIB, using a serial port (not USB adapter) and using the mic connector to program. Computer software is Windows XP Pro.
Codeplug 0010
Firmware 07.71
System Plug H37
Flash Code 000004-000000-6
I have loaded the CPS software on two different computers and I get the same results.
Any ideas as to what is happening? Is there a way to lock the codeplug so that you can't upload to the radio nor save the codeplug?
David
'This program has requested the runtime to terminate it in an unusual way. Contact application support team ~'
I have an MCS2000 900mhz radio and I have no problem programming it or saving the codeplug. I have the Motorola RIB, using a serial port (not USB adapter) and using the mic connector to program. Computer software is Windows XP Pro.
Codeplug 0010
Firmware 07.71
System Plug H37
Flash Code 000004-000000-6
I have loaded the CPS software on two different computers and I get the same results.
Any ideas as to what is happening? Is there a way to lock the codeplug so that you can't upload to the radio nor save the codeplug?
David