Minitor V Squelch noise after transmission
Posted: Sun May 12, 2013 4:23 pm
After every transmission there is a squelch noise from my pager. It last about .5 seconds. Is there any way I can change this in the engineering mode?
If you have and are using the Stored Voice Option, the open squelch is a feature. The radio holds squelch open for a predetermined length of time in case the dispatcher drops carrier between the tones and the message. Happens a lot. The length of time that it stays in open squelch can be adjusted without engineering mode. Go to the Model Options tab, and down at the bottom, the Reset Function is probably set to Revert N or Delayed N. N is the amount of time the radio is held in open squelch. It can be changed right there. If you use the SV option, lowering the time will almost certainly mean that you will not get a recording every now and then.modernmidnight wrote:After every transmission there is a squelch noise from my pager. It last about .5 seconds. Is there any way I can change this in the engineering mode?