Page 1 of 1
Posted: Sat Nov 17, 2001 10:09 am
by Guest
my saber is not tx or rx DPL...what might be causing this????and is it easy to fix???
thanks
Posted: Sat Nov 17, 2001 10:50 am
by HOWARD
Did it all of a sudden start doing this or was like this when you got it? I had an Astro Saber with a bad flash code (hacked) and it caused that problem.
Howard
Posted: Sat Nov 17, 2001 10:57 am
by Guest
i got the unit like this...my tech told me it was high deviation,,,they hve to adjust it
Posted: Sat Nov 17, 2001 11:12 am
by Guest
is this east to fix,,or will i have to send it to motorola depot,,what can be the cause other then a flashcode issue..
Posted: Sat Nov 17, 2001 11:29 am
by FDNY
i am having the same problem,,,i am new with this saber equipment...any clues to waht might be wrong and is it expensive to fix,,,anyone with info pleae reply
thanks
THE F.D.N.Y.
Posted: Sat Nov 17, 2001 12:03 pm
by Elroy Jetson
The radio needs to have its PL deviation properly adjusted by a service tech with the RSS, RIB, service/program cable, and a service monitor. It's a fifteen minute job, tops, and any well equipped service shop should be able to handle it, if they're familiar with that type of radio and have the supplies necessary.
Elroy
Posted: Sat Nov 17, 2001 8:00 pm
by radiorepair
Are we talking about an Astro or analog Saber?