Batboard

I have two HT1250s that I use Daily, one is uhf one is vhf.
the uhf scan settings seem to work fine, however the VHF one doesn't seem like to any settings i try to use. I originally just copied scan settings from the UHF radio ( this one USES NO PL) but the VHF uses PL. I was able to get the radio to only land on scan channel when pl is TX but if I sit on a personality it will not open audio for that personality. Is there someone here that possibly knows what I might have set wrong?

Java wrote:I have two HT1250s that I use Daily, one is uhf one is vhf.
the uhf scan settings seem to work fine, however the VHF one doesn't seem like to any settings i try to use. I originally just copied scan settings from the UHF radio ( this one USES NO PL) but the VHF uses PL. I was able to get the radio to only land on scan channel when pl is TX but if I sit on a personality it will not open audio for that personality. Is there someone here that possibly knows what I might have set wrong?

PM sent.

was everything set to be in the scan bank