XTL5000 home system ID highlighted in red??
Posted: Thu Oct 06, 2016 12:03 pm
I came into this problem when I was programming my XTS5000 and I dont remember how I fixed it, hoping someone on here can help!
I have a XTL5000 radio I am trying to program identical to my XTS5000 however I for some reason cannot locate my programming cable for the XTS to look at the code plug for reference so I am trying to do this from the beginning. I have a system key for my P25 system I am programming. The radio is a 9600 baud radio as is the XTS. In the XTL CPS (20.01.00) I have went to Tools>System Keys>Load>Software System Key and it accepts it just fine. I go to the System Keys Report and it shows the correct key ID. When I go to the Trunking System in the code plug and go under General tab I change the System Type to ASTRO 25 and I go down to the ASTRO 25 section where it says Home System ID and type in my ID which is A73C and I hit tab and the words Home System ID go red. When I go to the Trunking Personality it already has populated the system & ID and everything seems fine. Like I said this happened to me when I was programming my XTS5000 but I do not remember what I did to get it fixed. Any suggestions??
I have a XTL5000 radio I am trying to program identical to my XTS5000 however I for some reason cannot locate my programming cable for the XTS to look at the code plug for reference so I am trying to do this from the beginning. I have a system key for my P25 system I am programming. The radio is a 9600 baud radio as is the XTS. In the XTL CPS (20.01.00) I have went to Tools>System Keys>Load>Software System Key and it accepts it just fine. I go to the System Keys Report and it shows the correct key ID. When I go to the Trunking System in the code plug and go under General tab I change the System Type to ASTRO 25 and I go down to the ASTRO 25 section where it says Home System ID and type in my ID which is A73C and I hit tab and the words Home System ID go red. When I go to the Trunking Personality it already has populated the system & ID and everything seems fine. Like I said this happened to me when I was programming my XTS5000 but I do not remember what I did to get it fixed. Any suggestions??