Batboard

I have not used the APX CPS for quite some time, but I decided to give it a try tonight. However, I can't seem to get my Windows 10 computer to see my APX7000. I think, in the past, when it connected successfully, it would show up as a connected device. I am not real computer savvy, but I am wondering if I need USB drives for this. Does anybody have any idea where I can get these?

It might not be your computer; it might be your codeplug.

There's a codeplug option to only recognize devices when the radio is powered up. If that option is on, you have to turn the radio on AFTER you've connected it to the computer.

I accidentally set this once, and I spent hours debugging the USB setup before I figured out what was happening.

Jim1348 wrote:I have not used the APX CPS for quite some time, but I decided to give it a try tonight. However, I can't seem to get my Windows 10 computer to see my APX7000. I think, in the past, when it connected successfully, it would show up as a connected device. I am not real computer savvy, but I am wondering if I need USB drives for this. Does anybody have any idea where I can get these?

Was this a computer that you upgraded from Win7 or Win8 to Win10? And if so was the APX CPS already installed on said computer before the OS upgrade? If so you just need to uninstall APX CPS then do a fresh install of APX CPS in Win10.
Marshall KE4ZNR

I just installed CPS 15.00.01 on my Windows 10. I did not uninstall CPS 14.00.00 and the new CPS did not uninstall it. CPS 15.00.01 does not find my archs. If I unstall CPS 14.00.00 will I loose my existing archs?