Batboard

Good day to all
I have just received a new to me R2001D service monitor. When plugged in, the oven ready and AC leds light, but nothing else. I have found a blown (exploded) RT1 thermistor on the A3 card. The manual lists the part as 06-80342B85 but I cannot locate a source of supply. Any help would be greatly appreciated.

Thank you
Bill

RT2 shouldbe the same value RT1. Just pull and measure ..you may have to research an equivalent to match. You should also be able to look at the markings of the good one

Sounds like you need to replace the caps and possible both thermistors.

Thank you for the reply. RT2 is also damaged to the point that I don't trust the measurements. There are no markings.

should be 12 ohms