Page 1 of 1
sbaer III question
Posted: Thu Jul 10, 2003 9:52 am
by olderookie
I know it has been said but I can not find it how do you put a saber into test mode. some thing about pushing the right button as you turn it on?
thanks
Posted: Thu Jul 10, 2003 11:15 am
by RKG
For Systems Sabers, hold in the top three (red) buttons while powering up. I think, but am not positive, that it is same for original Sabers.
Posted: Thu Jul 10, 2003 3:21 pm
by JohnDo
Yes its the same for saber III
JK
Posted: Thu Jul 10, 2003 7:37 pm
by kc2dla
when I do this on my secure Saber III it displays the alphanumeric row completely solid and the secure indicator appears (slashed circle). No buttons function or change the display. Anything else I can make it do with this service/test mode?
Posted: Thu Jul 10, 2003 8:17 pm
by MT2000 man
I believe you have to press the monitor button (top "rubber" button on the side of the radio) 5 times rapidly while it powers up.
I think.
Let me know if that works.
Mike
On Edit -
I just tried that with my MT2000, and it worked. It displayed the Model #, did an RF test, and CH test. When I get my saber III back Friday I'll see if it does the same.