Page 1 of 1
CM200 MOBILE PROGRAMMING CABLE
Posted: Tue Dec 16, 2003 7:53 am
by itjisfo
DOES ANYBODY KNOW THE PINOUT FOR THE CM200 PROGRAMMING CABLE !!!!!! THANKS FOR YOUR HELP
Posted: Tue Dec 16, 2003 8:37 am
by Znarx
the CM/PM seres of mobiles program through the 16 pin accessory connector on the rear of the radio
data - pin #6
ground - pin #7
all you need to do is use your regular mobile cable, plug it into a modular telco box (8 pin) and use an accessory plug
....Z
Posted: Mon Nov 21, 2005 10:20 pm
by RINZY50671
"all you need to do is use your regular mobile cable, plug it into a modular telco box (8 pin) and use an accessory plug"
Trying to make a CM300 Cable. But I do not understand the above. Please help.
Posted: Tue Nov 22, 2005 4:25 am
by Nand
The cable is the same as the Maxtrac or GM300 and other Radius mobile cables with a jumper added at the radio end of the cable between the pin 1 and pin 3 of the RJ45.
Pin 1 would be the top pin when plugged in a Maxtrac with the RJ45 clip to the right in this example. Some call this pin 8.
http://batboard.batlabs.com/viewtopic.php?t=51120
Nand.