Batboard

Posted: **Thu Jan 01, 2004 2:31 pm**

fellas

I have a bit of a redundant question, but i am considering an ebay purchase and i wanted to pose a specific question(s) regarding what i propose.
I have factory legit ASIII host07.06.01 dsp07.03.19
flsh 500004 000000-1 Mod h04sdh9pw7an

there is an asII on ebay that i may bit on it is a mod H04SDF9PW7AN
Flash: 140004-000000-0 I emailed the seller for the host/dsp ser# but i dont yet have that info. What i want to know is in order to "send the ASIII codeplug into the ASII do the host and dsp's have to match exactly, or is there a minimum version that the radio I want has to be in order for the "good" asIII codeplug to be sent to it?

Also not to get too technical but if sombody i knew had access to the proper software to convert 1 codeplug to the other Mod II radio i thought there was something i read where the lab software was not compatable with imbe radios? Is this just for programming changes life freq's can lab software just clone the information without modification and work on an imbe radio?

thanks for reading/helping imput is much appreciated

Posted: **Thu Jan 01, 2004 2:35 pm**

You'll get your answer when R0f or XMO reads this post...

Posted: **Thu Jan 01, 2004 5:54 pm**

thanks so much for taking the time to not only reply, but to also give me a how to lesson as well. I will let you know if i get the radio but if not at least i know what to look for in future units.

THANKS
RADAR

Posted: **Thu Jan 01, 2004 11:59 pm**

MTSX lab?????? huh.. learn somethign new everyday lol.

Posted: **Fri Jan 02, 2004 5:37 am**

Dale Earnhardt wrote:MTSX lab?????? huh.. learn somethign new everyday lol.

Yes, it has been mentioned before, but the 'available' version of Astro LAB (3.04.00) is VSELP only. It doesn't recognize IMBE at all, and will give some sort of 'unrecoverable error' message when you try & read a codeplug. It will load the packed codeplug & allow you to write it to the radio, but you will end up with an error 01/92 or something similar. For whatever reason, the MTSX LAB 3.00.02 will not give the 'unrecoverable error' message, and works great to dump in the packed codeplug.

Todd

Posted: **Fri Jan 02, 2004 6:34 pm**

WELL
i have called all my "radio freinds" and told them what i need for the converrsion, hopefully one of them can come up with the correct version. I HOPE

I am sure i will owe them a big time favor but it will be worth it, i will let you all know how i make out.

thanks

Posted: **Fri Jan 02, 2004 10:06 pm**

hmmm, now I need to find a AS to mess around with now hehehe.

Posted: **Wed Jan 07, 2004 11:10 am**

Can you use any other MTSX lab version or is version 3.00.02 the only version you can use ?

Batboard

ASII to an ASIII

ASII to an ASIII