Batboard

XTS3000 Smartzone Firmware 6.11.03.00

When using priority monitor scan, it grabs the initial traffic great but then I miss the replies until it restarts the scan and regrabs it agian. I orignially had the RX hold on 3 Sec so I dropped it to 1 Sec and this helped but if it's an immediate reply then it's still cut off and lost if it grabs a different coversation.

Please help.

Thanks

rof,

you are correct about the priority scan. We are currently only using the analog system. No matter which TG I am monitoring (Pri or non) it has the same missed responses unless once again the rx hold time has expired and it reinitiates it's scan cycle.