Crown Vic 1998 Ignition Point
Posted: Wed Feb 23, 2005 10:43 am
Where is a good place to grab 12v switched ignition on a 1998 Crown Vic Police Package???
Thanks,
Nick
Thanks,
Nick
Page 1 of 1
Posted: Wed Feb 23, 2005 11:04 am
Two wires near passenger kick panel? Will those work?
Posted: Wed Feb 23, 2005 12:50 pm
It's been a while, but I remember a red, and a blue connector in the kick pannel. Red is battery, and blue is ignition.
Posted: Wed Feb 23, 2005 5:22 pm
That is correct. The are about 10 guage or so if I remember correctly. They sometimes terminate on a 3 unit plug in type of connector on each wire to make installs go somewhat easier.
Posted: Thu Feb 24, 2005 1:27 pm
Kuhn.. Have you ever worked on a PI before?
Posted: Fri Feb 25, 2005 4:09 pm
Apparently not 
Posted: Fri Feb 25, 2005 8:27 pm
I have been doing installs for a few years now, but mostly Personal Vehicles, Fire & EMS apparatus, and ect. I did my first radio install in a PI a few months ago, but there was already wiring terminated in the console, so it was simple. I knew there was such wiring pre-installed for this, but no idea where to look.
I have 30 PI's to do some install and uninstall work to in the next 4-5 weeks. I am just trying to get as much information as possible. When your only 17 its hard for some people to take you seriously when you ask questions like this so I appreciate the help.
I have 30 PI's to do some install and uninstall work to in the next 4-5 weeks. I am just trying to get as much information as possible. When your only 17 its hard for some people to take you seriously when you ask questions like this so I appreciate the help.