Wiring Question for a Saber Convertacom

The General forum is where users can discuss any topic regarding Motorola communications equipment - hardware, software, etc. There are also several focused forums on this board, so please take the time to ensure that your questions doesn't fall into one of those categories before posting here!

Moderator: Queue Moderator

Post Reply
dpd4703
Posts: 9
Joined: Sat Dec 18, 2004 10:42 pm

Wiring Question for a Saber Convertacom

Post by dpd4703 »

I am trying to wire a Saber Convertacom. It has a flat four pin connector on the rear. Any help on which pins are for power source and ground? I am using a connector obtained from a local electronics store...non-Motorola.

Thanks for any help.

Paul
Top
airman1952
Batboard $upporter
Posts: 36
Joined: Mon Jan 05, 2004 9:51 am

Post by airman1952 »

I asked the same question a while back and I was referred to this topic:

http://batboard.batlabs.com/viewtopic.php?t=1539

Gary
Top
dpd4703
Posts: 9
Joined: Sat Dec 18, 2004 10:42 pm

Thanks Airman1952

Post by dpd4703 »

I appreciate the information. Many thanks.
Top
Post Reply

Return to “General Motorola Solutions & Legacy Radio Discussion”