Batboard

I have a Install scheduled for a 2005 Ford F150 Install for the beginning of next week. I need some information because I have never even seen one up close.

Will probably need:

Good place for ignition point
strobe mounting location in headlights, reverse lights, and tailights
Mounting locations for siren/switch panel
siren speaker mount location
firewall access points

and any thing else you can think of!

Thanks!

Nick

KuhnElectronics wrote:I have a Install scheduled for a 2005 Ford F150 Install for the beginning of next week. I need some information because I have never even seen one up close.

Will probably need:

Good place for ignition point
strobe mounting location in headlights, reverse lights, and tailights
Mounting locations for siren/switch panel
siren speaker mount location
firewall access points

and any thing else you can think of!

Thanks!

Nick

-Use the fusebox for access to ignition sources, radio etc. obviously use relays when neccesary.
-headlight housings are limited because of design of reflective housings in the new 150's. On an angle drill the 1" hole next to the blinkers in the same housing. This keeps the strobe light output concentrated, and away from the headlight beam so it doesn't get washed out.
-Switching panel locations are minimal also, I used the overhead compartment for custom switches. I used a run of 4 conductor strobe cable to feed the switches and output to lights.
-Siren switches I can't say I worked with in this truck, because I only went with my horn ring to the AirHorn function.
-If you have a "low-profile" siren-speaker like fedsigs or sho-me's it fits like a glove in the lower grill to the side of the front license plate.
-If you look under your drivers side by the gas and brake pedals, there is a nice size grommet that goes through the firewall above the gas pedal. This has no factory use, so is perfect for strobe, siren, radio cables...

There is another thread on this truck I did in this vehicle install forum with links to pictures and video of this truck. It has been locked though so there are no replies allowed. http://batboard.batlabs.com/viewtopic.php?t=40557

My fire chief just got a 2005 4-door F-150. We sent it out to a local installer for an "all LED" installation. Of course I couldn't do without wig-wags,taillight flashers, and fog light strobes...

I will hopefully post pics tomorrow. Its very sharp. Jotto Desk makes a console that fits in just above the am/fm radio on the top of the dash; fits perfectly.

I JUST FINISHED DOING INSTALLS ON 3 F150 05 MODEL WITH THE WHELEN ULTRA LFL LIBERTY BAR WITH TRAFFIC ADVISOR AND CODE 3 3672 LIGHT CONTROL FOR THE FINNEY CO SO AND THEY WERE A BREEZE. A 3 RADIO BRACKET WORKS FINE IN FRONT OF MIDDLE SEAT\ CONSOLE, ANY QUESTIONS REGUARDING WIRE LOCATION OR WIRE FEED LOCATIONS FEEL FREE TO CONTACT ME,

Ack, please no yelling!!!


MAKE : FORD | MODEL : F SERIES LIGHT DUTY | YEAR : 2005

Type Color Polarity Location
12volts lt. green/purple (20A) + ignition harness
Starter red/lt. blue + ignition harness
Ignition dk. blue/lt. green + ignition harness
Accessory black/lt. green + ignition harness
Keysense black/pink + ignition harness
Power Lock pink/yellow - DKP or BCM, green plug, pin 9
Power Unlock pink/lt. green - DKP or BCM, green plug, pin 1
Lock Motor pink/black 5wi DKP or BCM, blue plug, pin 2
Unlock Motor red/orange 5wi DKP or BCM, blue plug, pin 5
Parking Lights+ brown + switch or BCM, blue plug, pin 6
Hazards same as turn signal wires
Turn Signal(L) lt grn/wht (F), lt grn/org (R) + turn signal switch
Turn Signal(R) wht/lt blu (F), org/lt blu (R) + turn signal switch
Reverse Light black/pink + DKP, gray plug, pin 13
Door Trigger black/yel (L), black/pink (R) - DKP, gray plug, pins 22, 23
Dome Supervision black/lt. blue + DKP, gray plug, pin 6
Tachometer NOT red/lt. green or red ac any ignition coil or fuel Inj
Brake Wire Lt. green + brake pedal switch
Parking Brake lt. green/red - parking brake switch
Horn Trigger dk. blue - switch or BCM, blue plug, pin 12

Aces-Warehouse wrote:Ack, please no yelling!!!


MAKE : FORD | MODEL : F SERIES LIGHT DUTY | YEAR : 2005

Type Color Polarity Location
12volts lt. green/purple (20A) + ignition harness
Starter red/lt. blue + ignition harness
Ignition dk. blue/lt. green + ignition harness
Accessory black/lt. green + ignition harness
Keysense black/pink + ignition harness
Power Lock pink/yellow - DKP or BCM, green plug, pin 9
Power Unlock pink/lt. green - DKP or BCM, green plug, pin 1
Lock Motor pink/black 5wi DKP or BCM, blue plug, pin 2
Unlock Motor red/orange 5wi DKP or BCM, blue plug, pin 5
Parking Lights+ brown + switch or BCM, blue plug, pin 6
Hazards same as turn signal wires
Turn Signal(L) lt grn/wht (F), lt grn/org (R) + turn signal switch
Turn Signal(R) wht/lt blu (F), org/lt blu (R) + turn signal switch
Reverse Light black/pink + DKP, gray plug, pin 13
Door Trigger black/yel (L), black/pink (R) - DKP, gray plug, pins 22, 23
Dome Supervision black/lt. blue + DKP, gray plug, pin 6
Tachometer NOT red/lt. green or red ac any ignition coil or fuel Inj
Brake Wire Lt. green + brake pedal switch
Parking Brake lt. green/red - parking brake switch
Horn Trigger dk. blue - switch or BCM, blue plug, pin 12

Ace-

Where are you getting this data from? I'm looking for wiring diagrams for my new 2005 F-350 Super Duty, mainly so I can add an alarm system (wired into the emergency lighting and siren... should make for a unique alarm response!) and a few other things. Can you get similar/more detailed info for other vehicles?

yea man, any vehicle.. I install alarms and stuff, great info... ill pm you your diagram.