mt2000 uhf

ean633 · Post by **ean633** » Mon Jun 06, 2005 12:36 pm

have a mt2000 uhf model h01sdd9aa4an

unit got wet will not power up

i know there is an internal fuse on one of the boards. i would like to check and see if this is the problem.

could someone point me in the right direction

thnx pete

RadioSouth · Post by **RadioSouth** » Mon Jun 06, 2005 12:42 pm

There's a chip fuse on the RF board right near the underside of the
power pins.

Will · Post by **Will** » Mon Jun 06, 2005 12:43 pm

Pete, most of the time the little ribon connectors go bad when the radio gets wet. Use ONLY a soft pencil eraser to clean the flex contacts. I have seen them arc over and burn the contacts on both the flex AND the sockets on the controller.

ean633 · Post by **ean633** » Mon Jun 06, 2005 1:51 pm

is the fuse located between the two battery power pins?