Page 1 of 1

spectra dash mount

Posted: Wed Jun 29, 2005 1:23 pm
by ean633
does the spectra dash mount have carrier detect and audio pins like the accessory connector on other models?

maybe in a different location?

i have looked on the model definition page but want to make sure?

thnx pete

Posted: Wed Jun 29, 2005 9:07 pm
by Mike B
The standard DB-15 dash mount Spectra rear connector comes in these configurations:
http://www.open.org/~blenderm/spectra/#j2dashrem

There are soldered in zero ohm chip jumpers used to configure the pins. A configuration jumper cold be removed and a wire used to connect up something else point to point, inside the radio drawer on the command board.