Batboard

Gents,

I'm attempting to program a Minitor IV pager with a Minitor cradle model number NYN8355B. Once I place the pager inside the crable, I get no connected indicator (red LED) from the pager RIB. I tried both Minitor III and IV pagers. Needless to say that the software fails to read. Any suggestions?

Thanks
Tim

Did you put the pager into "program mode"?

tpg

For some special reason I knew you would come through with the perfect solution to my problem. I placed it in PROGRAMMING MODE and it read perfectly. As always I appreciate everything.

Tim