Min 3 Factory Repair
Posted: Fri Nov 17, 2006 1:53 am
Got a Min 3 that had 5 year service on it. It expires in March 07. If i send it in for repair. Would I more than likely get a IV back.
Frank
Frank
Page 1 of 1
Posted: Fri Nov 17, 2006 8:03 am
I wouldn't think so because depot support for the Min III was extended through May 31, 2007.
Posted: Fri Nov 17, 2006 8:44 am
unless you get someone else's pager by accident, this will not happen
Posted: Fri Nov 17, 2006 9:16 am
In which case, you'll probably get a Minitor I with a Minitor III sticker stuck to the front 
Posted: Fri Nov 17, 2006 9:16 am
In which case, you'll probably get a Minitor I with a Minitor III sticker stuck to the front
Posted: Fri Nov 17, 2006 9:55 am
There were reports of this happening about 2-3 years ago. I don't think this is the case today. Flat rate for the pagers also went up last I checked. You used to be able to send them to the factory for $32 a pop, and they would come back tuned, aligned, tested, new nylon case and a set of batteries.
We sent a bunch of Director IISV's in a couple years ago before support ended on them (I think it's ended at least) and was able to get most of them retuned, casesed, tagged, and aligned.
-Alex
We sent a bunch of Director IISV's in a couple years ago before support ended on them (I think it's ended at least) and was able to get most of them retuned, casesed, tagged, and aligned.
-Alex