Page 1 of 1
Posted: Tue Oct 23, 2001 7:14 am
by bat man
Any of you "Bat" folks have any info on the conversion of a DPL optioned R100 to CTCSS PL? Have no book on the beast at this time.
Posted: Tue Oct 23, 2001 8:42 am
by wazzzzzzzzup
if i recall, the R100 is a programable unit, so in the tradition of the programmed products, you should be able to go into the program to change PL or DPL
Posted: Tue Oct 23, 2001 12:25 pm
by bat man
Your correct, programing is changable. Thats the easy part. There has to be a hardware change too. Even the software says there is a hardware change needed when the program is changed from DPL to CTCSS. I have optioned several of these r100's, but never had to convert one to CTCSS from DPL.
Posted: Tue Oct 23, 2001 1:21 pm
by Glen W Christen
Posted: Tue Oct 23, 2001 1:28 pm
by Glen W Christen
You have to change the micro to 51-06890J019 (WHITE LABEL).
RX command board C551 to 33uF C562 to 100 uF C811 to 1uF
TX command board C607 to 100uF
You MUST specify the WHITE LABEL ( if it is still available)
Posted: Tue Oct 23, 2001 1:46 pm
by Glen W Christen
OOPS! The other is to convert to DPL. To convert to CTCSS
RX command board U701 51-2455M16 C551 to 10 uF C562 10 uF C811 0.1 uf
TX command board U701 51-2455M16 C607 to 1 uF
Posted: Tue Oct 23, 2001 4:31 pm
by Monty
Hi:
Sorry to report but the R100 series are a
FIXED PL or DPL from the factory and can
not be changed easily.
If one does make the attempt,yopu must try
and obtain the IC's which are almost impossible to find, along with about a dozen
fixed componets in both the receive and transmitt section.
I would strongly recommend trying to obtain
a After market tone Panel such as a Zetron or
Com Spec.
I have a Extra Book ( about 2" thick ) if you are interested
Monty