Batboard

in the RSS for the maxtrac 300 what is the setting to make Pin 8 = COR active low RUIndicator follows tone if used. I need this setting to make this unit a mobile extender. i have read the info under both maxtrac and gm300 to make a repeater out of 2 of these radios and all i now need is the setting in rss. thanks for any help.

Brian

I dont have a codeplug with only 5 pins so I couldnt look and dont remember but 16 pin... go to radio wide press f9 then f4 to change pins

Do a search here for "repeater module" and that will probaly answer most of your questions.
I do build a repeater module that is plug and play on Radius and Maxtrac mobiles, and works with the older five pin logic board radio used for the transmitter. There is even a module for both radios having five pin logic board.
There are lots of these units in service in the US and Canada.