Hello again,
I am looking for a pinout for an MCS2K to an L3208A Digital Junction box, which will be remoted to an MC3K.
Thanks in advance.
MCS 2000 Pinout for dig remote
Moderator: Queue Moderator
-
- New User
- Posts: 82
- Joined: Fri Jun 27, 2008 6:46 am
-
- New User
- Posts: 82
- Joined: Fri Jun 27, 2008 6:46 am
Re: MCS 2000 Pinout for dig remote
I'll check the manual tomorrow -see if it has a schematic for ya.
"We sleep safe in our beds because rough men stand ready in the night to visit violence on those who would do us harm. "
Re: MCS 2000 Pinout for dig remote
The manual doesn't show the pinouts for the cable, but it does contain the following:
HKN6123 is the MCS2000-Digital Junction Box cable
Pin assignments for the MCS2000 radio port are as follows:
Pin 2 Ground
Pin 4 Ground
Pin 5 Busy Radio
Pin 6 Data+ Radio
Pin 9 Radio Connect
Pin 10 Ground
Pin 11 Receive Input A
Pin 13 Radio Transmit Out
Pin 18 Data- Radio
All other pins are not used.
Maybe this info, plus what's on the Batlabs page for the MCS2000 will get you started.
I'll try to ohm out a cable on Monday for you.
HKN6123 is the MCS2000-Digital Junction Box cable
Pin assignments for the MCS2000 radio port are as follows:
Pin 2 Ground
Pin 4 Ground
Pin 5 Busy Radio
Pin 6 Data+ Radio
Pin 9 Radio Connect
Pin 10 Ground
Pin 11 Receive Input A
Pin 13 Radio Transmit Out
Pin 18 Data- Radio
All other pins are not used.
Maybe this info, plus what's on the Batlabs page for the MCS2000 will get you started.
I'll try to ohm out a cable on Monday for you.
"We sleep safe in our beds because rough men stand ready in the night to visit violence on those who would do us harm. "