Page 1 of 1
XPR6500 Side Accessory Connector
Posted: Thu Aug 14, 2008 9:39 am
by rdmahurin
Anyone have the pinout for this handy? I looked in the model specific section and didn't see it listed. The reference CD that comes with the radios didn't have any information about it either. I need to build a listen only earplug adapter.
Thanks in advance.
Re: XPR6500 Side Accessory Connector
Posted: Fri Aug 15, 2008 9:07 am
by maelv
Hello rdmahurin
Here is the Pin out Diagram for the mototrbo portable radios from the CPS Help function
but before you start building something
as i recall i think that you need to tell the radio that there is some Accessory connected to the radio before is will put the audio out in the accessory connector
but i can not help you whit that but may bee some one else can...???
Maelv.....
Re: XPR6500 Side Accessory Connector
Posted: Tue Sep 09, 2008 12:07 pm
by rdmahurin
This was exactly what I needed -- THANKS!
We have headsets cables with the accessory connector on one end, and a 5-pin Switchcraft connector on the other. I just needed to determine which pins were speaker +/- to make a batch of mono earplug adapters.
Re: XPR6500 Side Accessory Connector
Posted: Sun May 10, 2009 6:31 am
by libuff
are there moto or aftermarket accy connectors? i'm thinking of modding a bluetooth adapter to the radio...
also based on the above shown link, is there any direct PTT pin?
on a different project, on the RF coax connector, does the outside ring = ground?